Prusa3D Forum

Notifications

Clear all

michael.c31

Group: Registered

Joined: 2017/08/06

Eminent Member

	so as a follow up to this it appears that the problem was th... In forum Assembly and first prints troubleshooting	6 years ago
	sorry about these not being on the build plate. It kind of g... In forum Hardware, firmware and software help	6 years ago
	Layer Shifts In forum Hardware, firmware and software help	6 years ago
	Update: No more jamming on my extruder after replacing MK2.5... In forum Assembly and first prints troubleshooting	6 years ago
	my mistake. i was referring to the PTFE tube that sits in th... In forum Assembly and first prints troubleshooting	6 years ago
	There are various work-arounds for this already posted here.... In forum Assembly and first prints troubleshooting	6 years ago
	so nice update. the PTFE tube ended up getting stretched out... In forum Assembly and first prints troubleshooting	6 years ago
	it failed again with a tip that measures at 2.03mm ramming a... In forum Assembly and first prints troubleshooting	6 years ago
	it failed again with a tip that measures at 2.03mm ramming a... In forum Assembly and first prints troubleshooting	6 years ago
	it seemed to help with stringy tips at normal / suggested pr... In forum Assembly and first prints troubleshooting	6 years ago
	started another print and red had a problem right off the ba... In forum Assembly and first prints troubleshooting	6 years ago
	started another print and red had a problem right off the ba... In forum Assembly and first prints troubleshooting	6 years ago
	i am wondering about going back a a 2.0mm hot end tube. Ar... In forum Assembly and first prints troubleshooting	6 years ago
	getting stuck in the PTFE tube in the hotend is a symptom an... In forum Assembly and first prints troubleshooting	6 years ago
	getting stuck in the PTFE tube in the hotend is a symptom an... In forum Assembly and first prints troubleshooting	6 years ago
	the green was not in use it was the white filament. and i ha... In forum Assembly and first prints troubleshooting	6 years ago
	The green one look pretty bad for PLA. Try with lower temp o... In forum Assembly and first prints troubleshooting	6 years ago
	the filament i am using is inland PLA. and the tips measure ... In forum Assembly and first prints troubleshooting	6 years ago
	i am going to high jack this post as i think i am in the sam... In forum Assembly and first prints troubleshooting	6 years ago
	The extruder motor current was set to a rather high value (3... In forum Hardware, firmware and software help	6 years ago

Page 1 / 2 Next

Forum Statistics

559 Forums

62.9 K Topics

442.7 K Posts

18 Online

67.6 K Members

Latest Post: Ensuring Object are Flat on the Bed Our newest member: pinklemonade Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed