|
tighten the idler bearings so it can spin freely but doesn't... In forum General discussion, announcements and releases |
7 years ago |
|
your idler pulleys are loose, tighten them so they can spin ... In forum Others (Archive) |
7 years ago |
|
clean your steelsheet with some soap, i had terrible adhesio... In forum Others (Archive) |
7 years ago |
|
so i'm also very disappointed from the mk3 and the support ... In forum General discussion, announcements and releases |
7 years ago |
|
So I was wrong, completely.
I switched to 3.1.1, and did som... In forum Others (Archive) |
7 years ago |
|
I completely rebuilt the Z-Axis, and still the Problem is pr... In forum Others (Archive) |
7 years ago |
|
It happens in normal mode as well as in stealth mode, its no... In forum Others (Archive) |
7 years ago |
|
I have exacly the same problem, i can't figure out what's ca... In forum Others (Archive) |
7 years ago |
|
So that the PSU skews the frame is a fact. I had always slig... In forum Others (Archive) |
7 years ago |
|
got my rods replaced, but only x and y xis, hope they will s... In forum Hardware, firmware and software help |
7 years ago |
|
so had contact to support some days ago because my rods are ... In forum Hardware, firmware and software help |
7 years ago |
|
So my MK3 was loud like a jet yesterday, so i decided to swa... In forum How do I print this? (Printing help) |
7 years ago |
|
my mk3 is freaking loud.
i have a prusa i3 from bq, complete... In forum Others (Archive) |
7 years ago |
