Notifications
Clear all
Merlin1974
Group: Registered
Joined: 2017/01/29
Active Member
1
|
Mk2.5 Hot End overheat but nozzle temp on screen shows corre... In forum Hardware, firmware and software help |
6 years ago | |
|
Hello, I was facing this issue too and I believe I have foun... In forum Others (Archive) |
6 years ago | |
|
Update: Switched to a .6 nozzle and my prints are coming out... In forum Others (Archive) |
6 years ago | |
|
I have this same clicking issue on both my Mk3 and Mk2.5 upg... In forum Others (Archive) |
7 years ago | |
|
Finally finished my 2.5 upgrade today, and when running the ... In forum Others (Archive) |
7 years ago |