Prusa3D Forum

Notifiche

Cancella tutti

mbrennwa

Gruppo: Registrato

Registrato: 2026/02/20

Active Member

	Did you ever get any further insights into this? I am strugg... Nel forum Hardware, firmware and software help	12 hours fa
	My temperature readings are off by more than 2 °C. I set the... Nel forum Hardware, firmware and software help	15 hours fa
	Tolerance on bed temperature (Core One L)? Nel forum Hardware, firmware and software help	2 days fa
	I don't see any setting for the level in dimmed mode on my C... Nel forum Hardware, firmware and software help	4 months fa
	That sounds like a good solution. However, I don't see a set... Nel forum Hardware, firmware and software help	4 months fa
	Simple on/off switch for the chamber light? Nel forum Hardware, firmware and software help	4 months fa

Statistiche Forum

613 Forum

71.9 K Discussioni

504.9 K Post

12 Online

82.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso