Notifications
Clear all
maurespo
maurespo
Group: Registered
Joined: 2018/03/20
Active Member
1
Thank you for the tips Bob: I've used some Prusament PLA, an...

In forum Print tips (Archive)

5 years ago
I've not posted photo of my cold pull, next time i made a ph...

In forum Print tips (Archive)

5 years ago
Thank you Voj: from the date I purchased my mk3, there were ...

In forum Print tips (Archive)

5 years ago
Thank you Opk, this is a very nice solution: after upgrade t...

In forum Print tips (Archive)

5 years ago
That line has been in the article for at least 6 months sinc...

In forum Print tips (Archive)

5 years ago
Ok Tim, thank you, and I'm happy that you found this funny: ...

In forum Print tips (Archive)

5 years ago
Ok Voj: sometimes I don't understand certain things: I've ne...

In forum Print tips (Archive)

5 years ago
Only a last consideration: why sometimes print was ok and so...

In forum Print tips (Archive)

5 years ago
Ok Voj, thank you. The facts: after a first clogging (I thin...

In forum Print tips (Archive)

5 years ago
Thank you tim: all clear. Next time, before every try, I mak...

In forum Print tips (Archive)

5 years ago
On every try, I remove the nozzle from the hot-end, for a fu...

In forum Print tips (Archive)

5 years ago
Thank you for this tip: I can assure you that in every new t...

In forum Print tips (Archive)

5 years ago
Ok, I've pulled out filament in steps like descripted in you...

In forum Print tips (Archive)

5 years ago
Ok guys, after some thermal paste on heatbreak and changed a...

In forum Print tips (Archive)

5 years ago
Thank you guys for tips and observations. It's incredible, b...

In forum Print tips (Archive)

6 years ago
Update: I've changed thermistor sensor installed on hot-end,...

In forum Print tips (Archive)

6 years ago
Prusament PLA: which temperature?

In forum Print tips (Archive)

6 years ago
Share: