Notifications
Clear all
mathieu.n
Group: Registered
Joined: 2016/07/15
Active Member
1
|
Upgraded firmware and also lowered PINDA even further, about... In forum Others (Archive) |
9 years ago | |
|
XYZ Calibration poking holes in bed In forum Others (Archive) |
9 years ago | |
|
Well, I did make sure everything was OK as far as this artic... In forum Others (Archive) |
9 years ago | |
|
Thermal Runaway Issue In forum Others (Archive) |
9 years ago | |
|
So when I print something through OctoPrint and have a live ... In forum Others (Archive) |
9 years ago | |
|
Live Z adjustment vs Slicer Z adjustment - printing using Oc... In forum Others (Archive) |
9 years ago | |
|
Thanks for all the replies!
PINDA is unprotected, I can try... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Some investigative checks online are suggesting adjusting cu... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Darn OSX keeps uploading phone-sourced pictures upside down.... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Layer shift on a large print (i3 mk2) In forum Prusa i3 kit (Archive) |
9 years ago |