Notifications
Clear all
marcus.b2
Group: Registered
Joined: 2016/12/20
Active Member
1
|
So I bought and installed a new nozzle and I get these bumpy... In forum Prusa i3 kit (Archive) |
8 years ago | |
|
Extruder clogging In forum Prusa i3 kit (Archive) |
8 years ago | |
|
Ok so i set the slicer to 0.05mm and checked "detect thin wa... In forum Print tips (Archive) |
8 years ago | |
|
Comparing the token and the lines from the calibration print... In forum Print tips (Archive) |
8 years ago | |
|
Thank you for all for your input! I only have the nozzle tha... In forum Print tips (Archive) |
8 years ago | |
|
Using 0.10mm detail setting In forum Print tips (Archive) |
8 years ago | |
|
Im using Slic3r Prisa edition 1.31.6
I have attached a toke... In forum Print tips (Archive) |
8 years ago | |
|
Looking at the edge of the outer ring i can actually see tha... In forum Print tips (Archive) |
8 years ago | |
|
Bad top layer In forum Print tips (Archive) |
8 years ago |