Prusa3D Forum

Notifications

Clear all

Marcin

Group: Registered

Joined: 2020/04/08

Active Member

	Mintemp Fixed - przerywa wydruk In forum Hardware, firmware i oprogramowanie - pomoc	4 years ago
	So I did turn on the thin wall detection in slicer and it so... In forum Assembly and first prints troubleshooting	5 years ago
	@peter-m26 I will try that. @neophyl Yes. In forum Assembly and first prints troubleshooting	5 years ago
	I have printed benchie as a test and it comes out fine. But ... In forum Assembly and first prints troubleshooting	5 years ago
	It is a brand new MK3 printer, that just came to me few days... In forum Assembly and first prints troubleshooting	5 years ago
	Hi, thanks, attached is the zip file of the project: landing... In forum Assembly and first prints troubleshooting	5 years ago
	Unplanned Holes in outside layer issue In forum Assembly and first prints troubleshooting	5 years ago

Forum Statistics

559 Forums

63 K Topics

443.2 K Posts

19 Online

67.8 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed