Notifications
Clear all
Marcel K
Group: Registered
Joined: 2021/05/21
Active Member
1
|
@cwbullet Thanks for the reply. I will take a look to some m... In forum PrusaSlicer |
4 years ago | |
|
@tim-2 Thanks. So it's definitly "standard", then I'm really... In forum PrusaSlicer |
4 years ago | |
|
@tim-2 I have an Ender 3 with a BMG-Extruder on a Volcano as... In forum PrusaSlicer |
4 years ago | |
|
@3ddruckbertl You go to the Print-Settings-Tab and then sele... In forum PrusaSlicer |
4 years ago | |
|
@kurvalak Hi there, did you solve the problem? I seem to hav... In forum Hardware, firmware and software help |
4 years ago | |
|
@tim-2 Thanks for your response. Don't worry about the print... In forum PrusaSlicer |
4 years ago | |
|
@cwbullet Yes, I switched the heater block to a Volcano-bloc... In forum PrusaSlicer |
4 years ago | |
|
Perimeter Start/End not connected with bigger nozzle In forum PrusaSlicer |
4 years ago |