|
For anyone who hasn't seen yet, Prusa released a RC firmware... En el foro Hardware, firmware and software help |
hace 5 months |
|
1. I generally leave it as the default in PrusaSlicer, then ... En el foro Hardware, firmware and software help |
hace 9 months |
|
Yesterday I tried swapping to T5, the one extruder that stil... En el foro Hardware, firmware and software help |
hace 9 months |
|
What firmware version? I've been running 6.2.0 alpha 2, it h... En el foro Hardware, firmware and software help |
hace 9 months |
|
I was pulling the filament out with the extruder door open. ... En el foro Hardware, firmware and software help |
hace 9 months |
|
This is what happens to me. I haven't tried opening the extr... En el foro Hardware, firmware and software help |
hace 9 months |
|
Another question to add to my list: Do you use a brass (or o... En el foro Hardware, firmware and software help |
hace 9 months |
|
I used some Priline PCCF (dried of course) with the Prusamen... En el foro Hardware, firmware and software help |
hace 10 months |
|
Idle filaments absorbing moisture in PTFE tubes En el foro How do I print this? (Printing help) |
hace 12 months |
|
I haven't had a USB error since installing 6.2.0 alpha even ... En el foro Hardware, firmware and software help |
hace 12 months |
|
I found Raise3D PA12 CF Support which does stick well when p... En el foro How do I print this? (Printing help) |
hace 12 months |
|
I installed 6.2.0 alpha which does seem to fix the USB issue... En el foro Hardware, firmware and software help |
hace 12 months |
|
Either I didn't do the shielding right, or it isn't the (sol... En el foro Hardware, firmware and software help |
hace 1 year |
|
I'm pretty sure I've replaced all loaded parts with PC-CF by... En el foro Hardware, firmware and software help |
hace 1 year |
|
Today I added some shielding to my LCD cable. Some copper ta... En el foro Hardware, firmware and software help |
hace 1 year |
|
I got this from support the other day, looks like the fix fo... En el foro Hardware, firmware and software help |
hace 1 year |
|
I didn't use pre-6.0 much, but I don't recall getting this i... En el foro Hardware, firmware and software help |
hace 1 year |
|
I was able to complete a 40h print the other day on 6.1.2 wi... En el foro Hardware, firmware and software help |
hace 1 year |
|
I've been working with Prusa support on this and I've starte... En el foro Hardware, firmware and software help |
hace 1 year |
|
I'm not sure if I've been lucky or if this prevents the issu... En el foro Hardware, firmware and software help |
hace 1 year |
