|
1. I generally leave it as the default in PrusaSlicer, then ... In forum Hardware, firmware and software help |
2 weeks ago |
|
Yesterday I tried swapping to T5, the one extruder that stil... In forum Hardware, firmware and software help |
2 weeks ago |
|
What firmware version? I've been running 6.2.0 alpha 2, it h... In forum Hardware, firmware and software help |
3 weeks ago |
|
I was pulling the filament out with the extruder door open. ... In forum Hardware, firmware and software help |
3 weeks ago |
|
This is what happens to me. I haven't tried opening the extr... In forum Hardware, firmware and software help |
3 weeks ago |
|
Another question to add to my list: Do you use a brass (or o... In forum Hardware, firmware and software help |
4 weeks ago |
|
I used some Priline PCCF (dried of course) with the Prusamen... In forum Hardware, firmware and software help |
4 weeks ago |
|
Idle filaments absorbing moisture in PTFE tubes In forum How do I print this? (Printing help) |
3 months ago |
|
I haven't had a USB error since installing 6.2.0 alpha even ... In forum Hardware, firmware and software help |
3 months ago |
|
I found Raise3D PA12 CF Support which does stick well when p... In forum How do I print this? (Printing help) |
3 months ago |
|
I installed 6.2.0 alpha which does seem to fix the USB issue... In forum Hardware, firmware and software help |
3 months ago |
|
Either I didn't do the shielding right, or it isn't the (sol... In forum Hardware, firmware and software help |
4 months ago |
|
I'm pretty sure I've replaced all loaded parts with PC-CF by... In forum Hardware, firmware and software help |
4 months ago |
|
Today I added some shielding to my LCD cable. Some copper ta... In forum Hardware, firmware and software help |
4 months ago |
|
I got this from support the other day, looks like the fix fo... In forum Hardware, firmware and software help |
4 months ago |
|
I didn't use pre-6.0 much, but I don't recall getting this i... In forum Hardware, firmware and software help |
4 months ago |
|
I was able to complete a 40h print the other day on 6.1.2 wi... In forum Hardware, firmware and software help |
4 months ago |
|
I've been working with Prusa support on this and I've starte... In forum Hardware, firmware and software help |
4 months ago |
|
I'm not sure if I've been lucky or if this prevents the issu... In forum Hardware, firmware and software help |
5 months ago |
|
I got a roll of ASA and tried both today. At default setting... In forum How do I print this? (Printing help) |
5 months ago |
