Notifications
Clear all
MadOtis
Group: Registered
Joined: 2019/03/06
Active Member
1
|
Mk4/MMU3 - Randomly ejecting filament & jamming In forum Hardware, firmware and software help |
11 months ago | |
| MK3S w/ MMU2S to MK3S+ Upgrade instructions | 4 years ago | |
| When you slice, look for single column supports. Slic3r wil... | 7 years ago | |
| The spaghetti is obviously the results of it trying to print... | 7 years ago | |
| Simple bed adhesion issue. Clean the bed so the supports st... | 7 years ago | |
| Spaghetti Monster prints | 7 years ago |