Notifications
Clear all
Lups
Group: Registered
Joined: 2018/03/18
Eminent Member
2
|
Extruder Temperature drops 10c for 1 or 2h In forum Hardware, firmware and software help |
7 years ago | |
| Hi, thanks for your replys. I checked the spool and it runs... | 7 years ago | |
| Layer shifts on big prints | 7 years ago | |
| No I didn't 😳 thanks for the tip, now it works. | 7 years ago | |
| Hi, thanks for your reply. I used Simplify3D again and now ... | 7 years ago | |
| Filament Sensor not working | 7 years ago | |
| Strange wall errors | 7 years ago |
Page 2 / 2
Prev