Notifications
Clear all
Lukeskymuh
Group: Registered
Joined: 2018/03/11
Active Member
1
|
@andrei Material dependant: yes. As it is known and could be... In forum PrusaSlicer |
5 years ago | |
|
@joantabb There are may ways to compensate this. It would be... In forum PrusaSlicer |
5 years ago | |
|
You should perform the test in the link. It is quite well re... In forum PrusaSlicer |
5 years ago | |
|
Temperature shrinking compensation In forum PrusaSlicer |
6 years ago | |
|
ok, added the topic to GitHub: In forum PrusaSlicer |
6 years ago | |
|
CTE correction In forum PrusaSlicer |
6 years ago | |
| I also had this Problem after 2 years of printing. I observe... | 6 years ago | |
| PrusaSlicer stop for embedded parts | 6 years ago |