Prusa3D Forum

Notifiche

Cancella tutti

Leigh213

Gruppo: Registrato

Registrato: 2021/02/24

Active Member

	Yes thanks -- the key issue was the infill being set to zero... Nel forum How do I print this? (Printing help)	4 years fa
	@tim-2 Wow ok. That does indeed look familiar with some pr... Nel forum How do I print this? (Printing help)	4 years fa
	@tim-2 Noted. Typical routine is washed & then isoprop... Nel forum How do I print this? (Printing help)	4 years fa
	Success! Thank you everyone for your assistance. I redid t... Nel forum How do I print this? (Printing help)	4 years fa
	@dan-rogers Infill -- that would explain a lot. I'm going t... Nel forum How do I print this? (Printing help)	5 years fa
	Dice_Holder_Round_Bottom 3mf file attached. Nel forum How do I print this? (Printing help)	5 years fa
	@tim-2 Thank you for the reply - I'll check the speed, nozzl... Nel forum How do I print this? (Printing help)	5 years fa
	PLA vendor, model or slicer issue? Nel forum How do I print this? (Printing help)	5 years fa

Statistiche Forum

585 Forum

68.7 K Discussioni

480.8 K Post

12 Online

77.2 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso