Notifications
Clear all
Laxdavi3
Skupina: Registrovaný
Přidal se: 2025/04/03
Active Member
1
|
Once you completed the slicing process. Make sure the "Plate... In forum PrusaSlicer |
před 2 days | |
| You may have done this already, but check the idler assembly... | před 10 months | |
|
Check the following: the hinge pins are seated correctlythe ... In forum Hardware, firmware and software help |
před 12 months | |
|
Try enabling the Touch Sig Workaround also. In forum Hardware, firmware and software help |
před 1 year | |
|
Did you check to see if the touch option is enabled? If not,... In forum Hardware, firmware and software help |
před 1 year |