Prusa3D Forum

Notifications

Clear all

lancer enkor

Group: Registered

Joined: 2025/04/23

Active Member

	I bought something cheap from aliexpress. It's pretty accura... In forum General discussion, announcements and releases	2 months ago
	I built mine from kit. I only had one issue with belt tensio... In forum General discussion, announcements and releases	3 months ago
	I made this alignment three weeks ago and it is still at sam... In forum Assembly and first prints troubleshooting	4 months ago
	It is disappointing, I found this error after failed print. ... In forum Assembly and first prints troubleshooting	4 months ago
	Try it with completely loosened belts. In forum Assembly and first prints troubleshooting	5 months ago
	Thank you for your feedback. I was used to my previous custo... In forum Hardware, firmware and software help	5 months ago
	Chamber preheating, is it usable? In forum Hardware, firmware and software help	5 months ago
	Mine also failed after assembly. Then I upgraded the firmwar... In forum Assembly and first prints troubleshooting	5 months ago
	Hmm, I sent them the link to the forum and the youtube video... In forum Assembly and first prints troubleshooting	5 months ago
	I had the same problem with my kit. After calibrating to 85H... In forum Assembly and first prints troubleshooting	5 months ago

Forum Statistics

585 Forums

68.2 K Topics

477.4 K Posts

11 Online

75.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed