Activity
 
Notifications
Clear all
Koyo
Koyo
Group: Registered
Joined: 2020/12/10
Active Member
1
I'll look into that, thanks. I'm thinking of just switching ...

In forum How do I print this? (Printing help)

3 years ago
One ongoing theory I have is that I'm either printing too co...

In forum How do I print this? (Printing help)

3 years ago
Consistent Clogging / Heatcreep with Hardened Steel Nozzle

In forum How do I print this? (Printing help)

3 years ago
Update: I got a replacement rod, and just swapped it out. It...

In forum Hardware, firmware and software help

4 years ago
@swiss_cheese Thank you so so much for confirming that it's ...

In forum Hardware, firmware and software help

4 years ago
@blauzahn Thank you so much for sharing your measurements so...

In forum Hardware, firmware and software help

4 years ago
Actually, a correction on the rod spacing. It's actually not...

In forum Hardware, firmware and software help

4 years ago
@blauzah Thank you for the great suggestions! I think you're...

In forum Hardware, firmware and software help

4 years ago
Several Problems emerging with my MK3S

In forum Hardware, firmware and software help

4 years ago
Just wanted to follow up in case anyone was dealing with thi...

In forum Hardware, firmware and software help

4 years ago
Z-Band of sorts only on a certain model at a specific layer ...

In forum Hardware, firmware and software help

4 years ago
PSA: If you're having scarring/scratching on your top layer,...

In forum How do I print this? (Printing help)

4 years ago
I think the left one has to be the upright one for sure. I t...

In forum How do I print this? (Printing help)

4 years ago
I think standing up is the best way to get detail. When I fi...

In forum How do I print this? (Printing help)

4 years ago
I've had good success with 85A TPU on a stock machine. The g...

In forum How do I print this? (Printing help)

4 years ago
Share: