|
I contacted Prusa chat support about the issue, and he said ... Nel forum Hardware, firmware and software help |
6 years fa |
|
Did you ever find out what was causing the ratteling noise? ... Nel forum Hardware, firmware and software help |
6 years fa |
|
Thanks for the answer...
Didn't work, though..
at what spe... Nel forum Assembly and first prints troubleshooting |
6 years fa |
|
MMU filament loading grinds when printing, not when calibrat... Nel forum Assembly and first prints troubleshooting |
6 years fa |
|
Using Colorprint and Post Processor with MMU, The wipe tower... Nel forum Others (Archive) |
7 years fa |
|
Shipping table for the multicolor kit? Nel forum Others (Archive) |
8 years fa |
|
The 10cm calibration trick:
You choose a spot on your filam... Nel forum Others (Archive) |
8 years fa |
|
I'm from norway too, and I bought IPA at kjell.com
99.5% s... Nel forum Others (Archive) |
8 years fa |
|
JohnOFII:
Been using your Raptor PLA normal 0.2 S3D setting... Nel forum Others (Archive) |
8 years fa |
|
I use
Works for me every time for PLA, and ASA. ABS I stil... Nel forum Others (Archive) |
8 years fa |
|
John:
I don't have a PI3, but I do have a couple of PI 2's.... Nel forum Others (Archive) |
8 years fa |
|
Those look nice, John. I tried your MG Raptor PLA settings ... Nel forum Others (Archive) |
8 years fa |
|
JohnOFII:
I've compressed it with zip as I can't attach an ... Nel forum Others (Archive) |
8 years fa |
|
That did the trick.. I haven't compared them yet, but the on... Nel forum Others (Archive) |
8 years fa |
|
JohnOFII:
I downloaded your .fff file from github to try ou... Nel forum Others (Archive) |
8 years fa |
|
patrik.r:
Thanks! Well.. from total failure to record break... Nel forum Others (Archive) |
8 years fa |
|
JohnOCFil:
Thanks, I will give that profile a try with my G... Nel forum Others (Archive) |
8 years fa |
|
patrik.r:
I used the paper method only to dial in the hoten... Nel forum Others (Archive) |
8 years fa |
|
Wow.. So many profiles to choose from!
Which one to choose?... Nel forum Others (Archive) |
8 years fa |
|
Oh! Thanks alot for sharing those configs for Simplify3D!
L... Nel forum Others (Archive) |
8 years fa |
