Notifications
Clear all
Kenork
Group: Registered
Joined: 2018/04/26
Active Member
1
|
tx for the fast answer ! I did not clean. And when I wanted ... In forum Hardware, firmware and software help |
2 years ago | |
|
filament sensor MK3 In forum Hardware, firmware and software help |
2 years ago | |
|
so, if I put motor X on extruder control, nothing happens, a... In forum Hardware, firmware and software help |
7 years ago | |
|
Extruder axis does not move In forum Hardware, firmware and software help |
7 years ago | |
| Hi, I just installed octoprint, and all motors are ok excep... | 7 years ago |