Ken G. – Aktywność – Prusa3D Forum

Notifications

Clear all

Ken G.

Grupa: Zarejestrowany

Dołączył: 2019/11/30

Eminent Member

	Are you using ABS? If so, you may want to put the heated bed... In forum How do I print this? (Printing help)	5 years temu
	Turns out Target sells 91% Hope this helps, Ken In forum How do I print this? (Printing help)	5 years temu
	Set the bed temp to 80 and it sticks, I also put a space hea... In forum Assembly and first prints troubleshooting	5 years temu
	Hello all, Appreciate the assistance. Learned some new thi... In forum Assembly and first prints troubleshooting	5 years temu
	Hello all, Thank you, it was a clogged extruder. Sailed th... In forum Assembly and first prints troubleshooting	5 years temu
	Hi lichtjaeger, I did this. Going to see if something is b... In forum Assembly and first prints troubleshooting	5 years temu
	Thank you Bobstro, I tried that, but it made no difference... In forum Assembly and first prints troubleshooting	5 years temu
	Out of curiosity, when machine powers up, do the fans come o... In forum Assembly and first prints troubleshooting	5 years temu
	Built the machine, but when I do the first layer calibration... In forum Assembly and first prints troubleshooting	5 years temu

Strona 3 / 3 Wstecz

Statystyki Forum

559 Fora

62.8 K Tematy

442.4 K Posty

20 Online

67.4 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte