Ken G. – Activité – Prusa3D Forum

Notifications

Clear all

Ken G.

Groupe: Enregistré

A(ont) rejoint: 2019/11/30

Eminent Member

	Are you using ABS? If so, you may want to put the heated bed... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Turns out Target sells 91% Hope this helps, Ken Dans le forum How do I print this? (Printing help)	il y a 5 years
	Set the bed temp to 80 and it sticks, I also put a space hea... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Hello all, Appreciate the assistance. Learned some new thi... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Hello all, Thank you, it was a clogged extruder. Sailed th... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Hi lichtjaeger, I did this. Going to see if something is b... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Thank you Bobstro, I tried that, but it made no difference... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Out of curiosity, when machine powers up, do the fans come o... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Built the machine, but when I do the first layer calibration... Dans le forum Assembly and first prints troubleshooting	il y a 5 years

Page 3 / 3 Précédent

Statistiques du forum

559 Forums

62.8 K Sujets

442.6 K Messages

21 En-ligne

67.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé