Notifications
Clear all
Kavan
Skupina: Registrovaný
Přidal se: 2021/09/03
Active Member
1
| Thanks Bob! I never had an issue with the prints not st... | před 4 years | |
| Z-offset and bed leveling | před 4 years | |
|
Thanks, this is super helpful! I didn't know that about larg... In forum How do I print this? (Printing help) |
před 4 years | |
|
Print curves up at edges/corners? In forum How do I print this? (Printing help) |
před 4 years | |
| I don't think I'll re-print it. I wanted to have the top hav... | před 4 years | |
| Bottom side detail | před 4 years |