Notifications
Clear all
Kavan
Group: Registered
Joined: 2021/09/03
Active Member
1
| Thanks Bob! I never had an issue with the prints not st... | 3 years ago | |
| Z-offset and bed leveling | 3 years ago | |
|
Thanks, this is super helpful! I didn't know that about larg... In forum How do I print this? (Printing help) |
3 years ago | |
|
Print curves up at edges/corners? In forum How do I print this? (Printing help) |
3 years ago | |
| I don't think I'll re-print it. I wanted to have the top hav... | 3 years ago | |
| Bottom side detail | 3 years ago |