Aktivität
 
Benachrichtigungen
Alles löschen
Kai
Kai
Gruppe: Registriert
Beigetreten: 2017/11/03
Famed Member
In my case it was the slighly lifting of the heatbed / y-car...

Im Forum Assembly and first prints troubleshooting

Vor 7 years
Btw. the (sliding) Igus bearings have a lot of side clearanc...

Im Forum Assembly and first prints troubleshooting

Vor 7 years
You should also test it without the Belt atached to the Bed/...

Im Forum Assembly and first prints troubleshooting

Vor 7 years
For me the stock Bearings worked very well. Theres no need t...

Im Forum Assembly and first prints troubleshooting

Vor 7 years
Just wipe it with au tissue before any lubricant drops down ...

Im Forum General discussion, announcements and releases

Vor 7 years
Then you should just contact the support. It´s absolutely ea...

Im Forum Others (Archive)

Vor 7 years
I bet you already try´d to plug the ribbon cables out and ba...

Im Forum Others (Archive)

Vor 7 years
I use the black PETG from Prusa. It works fine for me. With...

Im Forum Others (Archive)

Vor 7 years
I have just taken the stl files and sliced them with the Pru...

Im Forum Others (Archive)

Vor 7 years
I guess that is one of the reasons why the extruder ist prin...

Im Forum Others (Archive)

Vor 7 years
I have the same problems (only with layer hights < 0.1). ...

Im Forum Others (Archive)

Vor 7 years
I re-designed some clamps i found on thingiverse. Now i have...

Im Forum Others (Archive)

Vor 7 years
Why don´t you just give it a try with some dish washing liqu...

Im Forum Others (Archive)

Vor 7 years
When i try new Filament that is kind of "special", i normall...

Im Forum Others (Archive)

Vor 7 years
If anyone can help I'm having a similar problem. I had to re...

Im Forum Others (Archive)

Vor 7 years
Hi andres, maybe it is better to think about a small stripe...

Im Forum Others (Archive)

Vor 7 years
Very nice tool!

Im Forum Others (Archive)

Vor 7 years
91% Acetone, or 91% isopropanol?

Im Forum Others (Archive)

Vor 7 years
Here´s one example.

Im Forum Others (Archive)

Vor 7 years
Disable your Filament Sensor. It could be a problem with the...

Im Forum Others (Archive)

Vor 7 years
Seite 130 / 132
Teilen: