Notifications
Clear all
jvasileff
jvasileff
Group: Registered
Joined: 2023/05/06
Trusted Member
3
I noticed mine were loose too, which caused Y axis calibrati...

In forum General discussion, announcements and releases

10 months ago
I meant for the US, which is relevant for this thread

In forum General discussion, announcements and releases

1 year ago
Ha, yeah, that's true and brings up another point. Prusa doe...

In forum General discussion, announcements and releases

1 year ago
> Please provide advise from US Customs to the contrary. ...

In forum General discussion, announcements and releases

1 year ago
You are mistaken. Nah, not mistaken. For whatever reason, th...

In forum General discussion, announcements and releases

1 year ago
It really depends on how unlucky you are. Not everyone is ch...

In forum General discussion, announcements and releases

1 year ago
See/p>

In forum General discussion, announcements and releases

1 year ago
As I understand it, a license fee must be paid to include ex...

In forum General discussion, announcements and releases

1 year ago
In my experience: Clean the sheet, even if it already seems ...

In forum How do I print this? (Printing help)

1 year ago
You might have missed the initial full probe. I've noticed t...

In forum General discussion, announcements and releases

1 year ago
I used the two light versions of these: They are really grea...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
After upgrading firmware to 5.0.0-RC, I was able to print bo...

In forum How do I print this? (Printing help)

1 year ago
So it seems that most prefer gyroid, or at least can't provi...

In forum General discussion, announcements and releases

1 year ago
So it seems that most prefer gyroid, or at least can't provi...

In forum General discussion, announcements and releases

1 year ago
There should be plenty of headroom for LEDs. I've been using...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Folks have reported corruption with 4.7.x, so I don't think ...

In forum Input Shaper (MK4)

1 year ago
The fan must have a faulty tachometer or a break in the wire...

In forum Hardware, firmware and software help

1 year ago
They probably just need a good cleaning, even if they alread...

In forum General discussion, announcements and releases

1 year ago
Any unexpected printer behavior could be a symptom. The key ...

In forum Input Shaper (MK4)

1 year ago
Wow, I really disagree with that. Do you have a link to thei...

In forum Input Shaper (MK4)

1 year ago
Page 1 / 4
Share: