Notifications
Clear all
jussi.p
Group: Registered
Joined: 2018/01/03
Active Member
1
How much current is too much for xy-steppers? High power set... In forum Others (Archive) |
6 years ago | |
Hi,
Probably I use most 0.6 and 0.8 nozzles, I ordered 0.4,... In forum Hardware, firmware and software help |
6 years ago | |
Volcano settings In forum Hardware, firmware and software help |
6 years ago | |
I did run that first layer calibration without filament and ... In forum Hardware, firmware and software help |
7 years ago | |
I use slic3r prusa edition and nothing is changed from defau... In forum Hardware, firmware and software help |
7 years ago | |
Those calibrations what I was doing, I left printer cooling ... In forum Hardware, firmware and software help |
7 years ago | |
Z-live adjust problems and bent bed on mk2s In forum Hardware, firmware and software help |
7 years ago |