|
Maybe I wrote too early: The belt will move in a bit when pr... In forum General discussion, announcements and releases |
6 months ago |
|
Yes, it's the same in my build, and I don't see how anything... In forum General discussion, announcements and releases |
6 months ago |
|
There is no dedicated locking. I think they are just relying... In forum General discussion, announcements and releases |
6 months ago |
|
After the X rail has been mounted onto the Y rods (step 5.35... In forum General discussion, announcements and releases |
6 months ago |
|
Oh, and another tip: If you have an M3 tap (thread cutter) i... In forum General discussion, announcements and releases |
6 months ago |
|
General recommendation: With hindsight, I wish I had prepare... In forum General discussion, announcements and releases |
6 months ago |
|
I am wondering whether maybe the whole crisis was simply due... In forum General discussion, announcements and releases |
6 months ago |
|
That's a very diffuse and abstract report. Unless you can be... In forum General discussion, announcements and releases |
6 months ago |
|
In steps 4.31 and 4.32 of the assembly instructions, the tra... In forum General discussion, announcements and releases |
6 months ago |
|
If only parts are imported into the U.S. you would avoid pay... In forum General discussion, announcements and releases |
6 months ago |
|
Just an observation: Those laser-cut (?) frame profiles make... In forum General discussion, announcements and releases |
6 months ago |
|
Yes, those are the ones. Once the X gantry is fully installe... In forum General discussion, announcements and releases |
6 months ago |
|
Pleasant little surprise regarding the feet -- you might hav... In forum General discussion, announcements and releases |
6 months ago |
|
I'm in no rush! But I obviously can't work on anything else ... In forum General discussion, announcements and releases |
6 months ago |
|
Aha, found it at last. Well-hidden at the bottom of the "ele... In forum General discussion, announcements and releases |
6 months ago |
|
First stumbling block: I can't find the third Z motor + lead... In forum General discussion, announcements and releases |
6 months ago |
|
I will add a bit of trivia first -- let's put it into the "s... In forum General discussion, announcements and releases |
6 months ago |
|
I just checked and rectified the two angle brackets from my ... In forum Assembly and first prints troubleshooting |
6 months ago |
|
Turns out that they are not as tough as one might think -- p... In forum General discussion, announcements and releases |
6 months ago |
|
All parts are in good shape, as far as I can see. The inner ... In forum General discussion, announcements and releases |
6 months ago |
