|
Infill before walls not working? In forum Cura, Simplify3D, Kisslicer, ... |
4 years ago |
|
Not sure if I'm able to help much given that there's not too... In forum Hardware, firmware and software help |
4 years ago |
|
ok, ignore this! this was all my fault.... had 'other layers... In forum Hardware, firmware and software help |
4 years ago |
|
seems to be a gcode generation problem In forum Hardware, firmware and software help |
4 years ago |
|
strange maxtemp hit? is this a slicer problem? mk3s+ and pru... In forum Hardware, firmware and software help |
4 years ago |
|
Sadly I closed that specific prusa project, but the files ar... In forum PrusaSlicer |
4 years ago |
|
So i decided to try slowing just that one part down with a m... In forum PrusaSlicer |
4 years ago |
|
Here is the bottom of the latest failed print, it looks a bi... In forum PrusaSlicer |
4 years ago |
|
warping in mid air In forum PrusaSlicer |
4 years ago |
|
all i can think off is to check all the parameters that coul... In forum PrusaSlicer |
4 years ago |
|
setting the extrusion width to the same as the other paramet... In forum PrusaSlicer |
4 years ago |
|
Actually, I just came to think of this... the original model... In forum PrusaSlicer |
4 years ago |
|
Strange perimiter "skipping" In forum PrusaSlicer |
4 years ago |
