Notifications
Clear all
Jucytec
Group: Registered
Joined: 2017/04/26
Active Member
1
|
Compared to S3D, bridging improvement needed. (unless I miss... In forum PrusaSlicer |
5 years ago | |
|
Thank you all, the acceleration and jerk were all comparable... In forum PrusaSlicer |
5 years ago | |
|
@bobstro That setting sounds promising, i was comparing the ... In forum PrusaSlicer |
5 years ago | |
|
PrusaSlicer slower compared to S3D In forum PrusaSlicer |
5 years ago | |
|
SD Card won't load unless i cold reboot with the Card In In forum Hardware, firmware and software help |
6 years ago | |
| I installed the XT version of this, and also installed a sli... | 6 years ago | |
| What is the correct setting for Z Axis speed for our MK3s? ... | 6 years ago | |
| Question. While MK2 was capable was moving @ 100mm/s everyo... | 6 years ago | |
| Final Version, Tested from .05mm to .35mm on PET. First l... | 6 years ago | |
| Final Version, Tested from .05mm to .35mm on PET. First l... | 6 years ago | |
| I found some really off profiles here with some crazy Esteps... | 6 years ago | |
| I found some really off profiles here with some crazy Esteps... | 6 years ago |