Notifications
Clear all
jsada.xyz
jsada.xyz
Group: Registered
Joined: 2018/03/17
Active Member
1
Hi gnatI don't have heat gun but I am going to test the cold...

In forum How do I print this? (Printing help)

6 years ago
Shall I replace the nozzle?

In forum How do I print this? (Printing help)

6 years ago
I expended a lot of hours trying different things and many h...

In forum General discussion, announcements and releases

6 years ago
MMU gets stuck with firmware 3.7.1

In forum Hardware, firmware and software help

6 years ago
The update has many processes and usually finish verifying t...

In forum Hardware, firmware and software help

6 years ago
Check if the funds works properly. Try FINDA with piece of m...

In forum Assembly and first prints troubleshooting

6 years ago
If you want to check the status of sensors you can go to the...

In forum Assembly and first prints troubleshooting

6 years ago
What I do in those cases is configure the gcode as MMU and s...

In forum Hardware, firmware and software help

6 years ago
I am having the same problem.I glued a cople with contact gl...

In forum Hardware, firmware and software help

6 years ago
I just updated to the firmware 3.7.1 and now it is fixed 🙂

In forum Hardware, firmware and software help

6 years ago
Hi Peter, Thanks for your answer! It is good to know becaus...

In forum Hardware, firmware and software help

6 years ago
I said victory to early. As you saw printer and mmu were wo...

In forum Hardware, firmware and software help

6 years ago
Hi, Finally I reprinted the "extruder-idler-mmu2s" and calib...

In forum Hardware, firmware and software help

6 years ago
Hi steve.g I have been touching many things and I found som...

In forum Hardware, firmware and software help

6 years ago
I thought I also calibrated the IR sensor and figured everyt...

In forum Hardware, firmware and software help

6 years ago
IR filament sensor stops working (mk3s + mmu2s)

In forum Hardware, firmware and software help

6 years ago
Share: