Avisos
Vaciar todo
Josef Průša
Josef Průša
Grupo: Administrador
Registrado: 2015/04/26
Título: Miembro Admin
2
Loose pulley doesn't have to do anything with how tight the ...

En el foro Others (Archive)

hace 9 years
Speaking of settings, there were some changes in the setting...

En el foro Others (Archive)

hace 9 years
❓ in 3.0.10-alpha2 there was a (nice) new feature for the ...

En el foro Others (Archive)

hace 9 years
Hi Helmi, This happens when the connector is not fully plug...

En el foro Others (Archive)

hace 9 years
Has anyone else noticed this kind of problem with infill aft...

En el foro Others (Archive)

hace 9 years
on the drivers page why Linux users are redirected to the of...

En el foro Others (Archive)

hace 9 years
Yeah you can. I always make sure it is possible to do that.

En el foro Others (Archive)

hace 9 years
Drivers 1.7.5 RC2 with Slic3r Prusa Edition (Updated 18 Nov)

En el foro Others (Archive)

hace 9 years
I didn't upgrade to Sierra as it always breaks some stuff wh...

En el foro Others (Archive)

hace 9 years
Make sure you use non parfumed paper towels, some release oi...

En el foro Others (Archive)

hace 9 years
Hi guys, this is the new preheat protection where thermal ru...

En el foro Prusa i3 kit (Archive)

hace 9 years
For those of you that are interested in Cura development ......

En el foro General discussion, announcements and releases

hace 9 years
Not sure but your nozzle cooling fan is the other way around...

En el foro Others (Archive)

hace 9 years
3mm van neutahne direct nema 17

En el foro Ostatní (Archiv)

hace 9 years
Hi I sent you an email 🙂

En el foro General discussion, announcements and releases

hace 9 years
Only 2 rolls?

En el foro Others (Archive)

hace 10 years
Thank you guys for the kind words. We shipped few more rev...

En el foro Others (Archive)

hace 10 years
Hi, is it one motor or both motors? Check if you didn't acc...

En el foro Others (Archive)

hace 10 years
Página 5 / 39
Compartir: