Josef Průša – Aktivität

Benachrichtigungen

Alles löschen

Josef Průša

Gruppe: Admin

Beigetreten: 2015/04/26

Titel: Mitglied Admin

	Loose pulley doesn't have to do anything with how tight the ... Im Forum Others (Archive)	Vor 9 years
	Speaking of settings, there were some changes in the setting... Im Forum Others (Archive)	Vor 9 years
	❓ in 3.0.10-alpha2 there was a (nice) new feature for the ... Im Forum Others (Archive)	Vor 9 years
	Hi Helmi, This happens when the connector is not fully plug... Im Forum Others (Archive)	Vor 9 years
	Has anyone else noticed this kind of problem with infill aft... Im Forum Others (Archive)	Vor 9 years
	on the drivers page why Linux users are redirected to the of... Im Forum Others (Archive)	Vor 9 years
	Yeah you can. I always make sure it is possible to do that. Im Forum Others (Archive)	Vor 9 years
	Drivers 1.7.5 RC2 with Slic3r Prusa Edition (Updated 18 Nov) Im Forum Others (Archive)	Vor 9 years
	I didn't upgrade to Sierra as it always breaks some stuff wh... Im Forum Others (Archive)	Vor 9 years
	Make sure you use non parfumed paper towels, some release oi... Im Forum Others (Archive)	Vor 9 years
	Hi guys, this is the new preheat protection where thermal ru... Im Forum Prusa i3 kit (Archive)	Vor 9 years
	For those of you that are interested in Cura development ...... Im Forum General discussion, announcements and releases	Vor 9 years
	Not sure but your nozzle cooling fan is the other way around... Im Forum Others (Archive)	Vor 9 years
	3mm van neutahne direct nema 17 Im Forum Ostatní (Archiv)	Vor 9 years
	Hi I sent you an email 🙂 Im Forum General discussion, announcements and releases	Vor 9 years
	Only 2 rolls? Im Forum Others (Archive)	Vor 9 years
	Thank you guys for the kind words. We shipped few more rev... Im Forum Others (Archive)	Vor 9 years
	Hi, is it one motor or both motors? Check if you didn't acc... Im Forum Others (Archive)	Vor 9 years

Seite 5 / 39 Vorherige Nächstes

Forums-Statistiken

585 Foren

68.2 K Themen

477.8 K Beiträge

11 Online

75.9 K Mitglieder

Letzter Beitrag: What filament dryer to use? Unser neuestes Mitglied: ArtiVIVO Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen