Josef Průša – Aktivita

Notifications

Clear all

Josef Průša

Skupina: Admin

Přidal se: 2015/04/26

Název: Member Admin

	Loose pulley doesn't have to do anything with how tight the ... In forum Others (Archive)	před 9 years
	Speaking of settings, there were some changes in the setting... In forum Others (Archive)	před 9 years
	❓ in 3.0.10-alpha2 there was a (nice) new feature for the ... In forum Others (Archive)	před 9 years
	Hi Helmi, This happens when the connector is not fully plug... In forum Others (Archive)	před 9 years
	Has anyone else noticed this kind of problem with infill aft... In forum Others (Archive)	před 9 years
	on the drivers page why Linux users are redirected to the of... In forum Others (Archive)	před 9 years
	Yeah you can. I always make sure it is possible to do that. In forum Others (Archive)	před 9 years
	Drivers 1.7.5 RC2 with Slic3r Prusa Edition (Updated 18 Nov) In forum Others (Archive)	před 9 years
	I didn't upgrade to Sierra as it always breaks some stuff wh... In forum Others (Archive)	před 9 years
	Make sure you use non parfumed paper towels, some release oi... In forum Others (Archive)	před 9 years
	Hi guys, this is the new preheat protection where thermal ru... In forum Prusa i3 kit (Archive)	před 9 years
	For those of you that are interested in Cura development ...... In forum General discussion, announcements and releases	před 9 years
	Not sure but your nozzle cooling fan is the other way around... In forum Others (Archive)	před 9 years
	3mm van neutahne direct nema 17 In forum Ostatní (Archiv)	před 9 years
	Hi I sent you an email 🙂 In forum General discussion, announcements and releases	před 9 years
	Only 2 rolls? In forum Others (Archive)	před 10 years
	Thank you guys for the kind words. We shipped few more rev... In forum Others (Archive)	před 10 years
	Hi, is it one motor or both motors? Check if you didn't acc... In forum Others (Archive)	před 10 years

Stránka 5 / 39 Předchozí Další

Fórum Statistiky

598 Fóra

70.8 K Témata

496.2 K Příspěvky

14 Online

82.1 K Uživatelé

Poslední Příspěvek: Stringing and Print Defects With Prusament PETG Nový Uživatel: LuminusLupus Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed