|
It is great to see the Linear Advance back in the game!
- e... In forum General discussion, announcements and releases |
7 years ago |
|
I see that this is an old topic, but I'd like to add my obse... In forum Others (Archive) |
7 years ago |
|
So it's not just me... Thanks, Peter, it makes perfect sense... In forum Others (Archive) |
7 years ago |
|
Overextrusion at 0.35mm resolution In forum Others (Archive) |
7 years ago |
|
Sounds like that made the distance from nozzle to bed just a... In forum Others (Archive) |
7 years ago |
|
Jeff, your response convinced me even more to find an altern... In forum Others (Archive) |
7 years ago |
|
MK2S upgrade LM8UUs bearings question In forum Others (Archive) |
7 years ago |
|
I just figured out what was causing the ripples in my case, ... In forum Others (Archive) |
7 years ago |
|
Why the asymmetrical bed carriage? In forum Others (Archive) |
7 years ago |
|
Ridges on the sides In forum Others (Archive) |
8 years ago |
|
I know this is an old post, but I ran into the same issue ye... In forum Others (Archive) |
8 years ago |
|
Did you do the "S" upgrade? You only need to print the rear... In forum Others (Archive) |
8 years ago |
|
Slic3r feature suggestion: custom bed avoid areas, and wear ... In forum Improvements (Archive) |
8 years ago |
|
I like to use this one: - It is sturdy, and makes replacing... In forum Improvements (Archive) |
8 years ago |
|
but an effect that i described here has to be considered as ... In forum Improvements (Archive) |
8 years ago |
|
first thanks for that link to your little test (uploaded at ... In forum Improvements (Archive) |
8 years ago |
|
Flow Tune vs Extrusion Multiplier In forum Improvements (Archive) |
8 years ago |
|
The temperature calibration does not work so great for me. I... In forum Others (Archive) |
8 years ago |
|
I think (perhaps one of the senior members should confirm), ... In forum Others (Archive) |
8 years ago |
|
@Murloc992, what did you do between the two cases, to get it... In forum Prusa i3 kit (Archive) |
8 years ago |
