|
Another Z-offset Calibration Help Request In forum Assembly and first prints troubleshooting |
9 months ago |
|
This is what I'm seeing on my board. Sorry, it's not a great... In forum Hardware, firmware and software help |
1 year ago |
|
The problem I'm having is that both the little pins on the b... In forum Hardware, firmware and software help |
1 year ago |
|
I'm having this issue as well, having managed to first disco... In forum Hardware, firmware and software help |
1 year ago |
|
The issue with the power panic cable is that I had accidenta... In forum Hardware, firmware and software help |
1 year ago |
|
I did not turn it on first. The wires looked okay but I'm st... In forum Hardware, firmware and software help |
1 year ago |
|
Opening case of buddy board In forum Hardware, firmware and software help |
1 year ago |
|
Thanks, that seems to have done it. I was clearly wrongly co... In forum Hardware, firmware and software help |
1 year ago |
|
Sorry, had forgotten. Anyway, the settings were perfect befo... In forum Hardware, firmware and software help |
1 year ago |
|
Nozzle Suddenly Too Close After Crash In forum Hardware, firmware and software help |
1 year ago |
|
I managed to do the install (broke the left fan wires in the... In forum Assembly and first prints troubleshooting |
2 years ago |
|
Couple hot end questions In forum Assembly and first prints troubleshooting |
2 years ago |
|
Model not printing on project with multiple objects In forum How do I print this? (Printing help) |
2 years ago |
|
Thanks everyone. I've got it looking good in PLA on the smoo... In forum Assembly and first prints troubleshooting |
2 years ago |
|
I have tried washing with something along the lines of Ajax ... In forum Assembly and first prints troubleshooting |
2 years ago |
|
Sorry I'm so late getting these posted. These are 0.750 and ... In forum Assembly and first prints troubleshooting |
2 years ago |
|
Sudden loss of first layer adhesion after approximately 120 ... In forum Assembly and first prints troubleshooting |
3 years ago |
