Aktywność
 
Notifications
Clear all
jmone
jmone
Grupa: Zarejestrowany
Dołączył: 2018/11/23
Reputable Member
5
Thanks for the model idea. Trouble with this one is it will...

In forum General discussion, announcements and releases

5 years temu
Thanks for the back and forth as I think it is imported to g...

In forum General discussion, announcements and releases

5 years temu
So here is the simple model I'm think of using. 15g, 5m, 1h...

In forum General discussion, announcements and releases

5 years temu
From reading the Web Page, the 176c is the max "up to temp" ...

In forum General discussion, announcements and releases

5 years temu
So after too much research on Balance Scales, I have an Ohau...

In forum General discussion, announcements and releases

5 years temu
Mmmm I'm going to have to rethink the approach as the weight...

In forum General discussion, announcements and releases

5 years temu
Yesterday, I did a test run on some test spanners that I had...

In forum General discussion, announcements and releases

5 years temu
@tim-m30. I sure will. The plan is to leave the filament s...

In forum General discussion, announcements and releases

5 years temu
...and the other thing that apply heat will help with during...

In forum General discussion, announcements and releases

5 years temu
@guy-k2 There is also IR Drying! but lazzzzerssss 🙂 @tim-...

In forum General discussion, announcements and releases

5 years temu
@tim-m30 - I've been having a look at various presentations ...

In forum General discussion, announcements and releases

5 years temu
@tim-m30 Thanks for your posts (and I too am just an armchai...

In forum General discussion, announcements and releases

5 years temu
I did keep some weight measurement when printing some test s...

In forum General discussion, announcements and releases

5 years temu
...and I did test my vacuum that it was strong enough to boi...

In forum General discussion, announcements and releases

5 years temu
@tim-m30. I initially did not think to use my vaccuum pump b...

In forum General discussion, announcements and releases

5 years temu
I pulled out an older role of Nylon (Dupont Zytel) and Flex ...

In forum General discussion, announcements and releases

5 years temu
Sock Arrived. I just slit it to allow putting it on/off wit...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
My Magnum Clone arrived today and while it looks good, I'll ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
I have heaps of spares so did a "new" hot end build (easier ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
Mmmm my Mosquito Magnum (sans heat shield) has started to le...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
Strona 7 / 18
Share: