Prusa3D Forum

Notifiche

Cancella tutti

jimD

Gruppo: Registrato

Registrato: 2020/10/02

Trusted Member

	Snuff, I tried adding a tube like you did in addition to the... Nel forum PrusaSlicer	6 months fa
	Everything arrived and is installed. For good measure I did ... Nel forum PrusaSlicer	6 months fa
	I'm going to stand down for a few days. I noticed that the i... Nel forum PrusaSlicer	6 months fa
	thanks, i'll look at the cleaning the bed and recalibrate th... Nel forum PrusaSlicer	6 months fa
	Snuffleupagus I ran your file unaltered, and it detached fro... Nel forum PrusaSlicer	6 months fa
	thanks for the file. I'll try it in the morning with the spe... Nel forum PrusaSlicer	6 months fa
	I saved all the parameters from the project file you sent, a... Nel forum PrusaSlicer	6 months fa
	I agree a chamfer would probably print better but aesthetica... Nel forum PrusaSlicer	6 months fa
	Snuffleupagus, I did try to run it but it is for the mk3s no... Nel forum PrusaSlicer	6 months fa
	Early attempts had no support which gave the same poor print... Nel forum PrusaSlicer	6 months fa
	thanks. look at the first picture in the original post which... Nel forum PrusaSlicer	6 months fa
	I did another print and left the support material in place. ... Nel forum PrusaSlicer	6 months fa
	How can I increase the support contact area when using suppo... Nel forum PrusaSlicer	6 months fa
	Thanks for the help with the supports. I added the cylinder... Nel forum PrusaSlicer	7 months fa
	Yes I did have trouble getting abs to print. The problem s... Nel forum PrusaSlicer	7 months fa
	I'll give some petg or asa a try if I can find it in ivory. ... Nel forum PrusaSlicer	7 months fa
	Thanks for the extra effort. PLA is where I started. Unfortu... Nel forum PrusaSlicer	7 months fa
	Thanks for the help. Yes I'm using abs. Pla was too brittle.... Nel forum PrusaSlicer	7 months fa
	Good memory it is the bottom (sole) and negative battery con... Nel forum PrusaSlicer	7 months fa
	Here is what I get. Nel forum PrusaSlicer	7 months fa

Pagina 1 / 3 Avanti

Statistiche Forum

559 Forum

63.1 K Discussioni

443.7 K Post

22 Online

68 K Utenti

Post recenti: Who has suggestions/tips/tricks to modify Eibos Cyclopes to solve the spotted hot air problem (causing melted spools and filament)! Ultimo utente registrato: etiennep Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso