Activity
 
Notifications
Clear all
jimD
jimD
Group: Registered
Joined: 2020/10/02
Trusted Member
3
Snuff, I tried adding a tube like you did in addition to the...

In forum PrusaSlicer

6 months ago
Everything arrived and is installed. For good measure I did ...

In forum PrusaSlicer

6 months ago
I'm going to stand down for a few days. I noticed that the i...

In forum PrusaSlicer

6 months ago
thanks, i'll look at the cleaning the bed and recalibrate th...

In forum PrusaSlicer

6 months ago
Snuffleupagus I ran your file unaltered, and it detached fro...

In forum PrusaSlicer

6 months ago
thanks for the file. I'll try it in the morning with the spe...

In forum PrusaSlicer

6 months ago
I saved all the parameters from the project file you sent, a...

In forum PrusaSlicer

6 months ago
I agree a chamfer would probably print better but aesthetica...

In forum PrusaSlicer

6 months ago
Snuffleupagus, I did try to run it but it is for the mk3s no...

In forum PrusaSlicer

6 months ago
Early attempts had no support which gave the same poor print...

In forum PrusaSlicer

6 months ago
thanks. look at the first picture in the original post which...

In forum PrusaSlicer

6 months ago
I did another print and left the support material in place. ...

In forum PrusaSlicer

6 months ago
How can I increase the support contact area when using suppo...

In forum PrusaSlicer

6 months ago
Thanks for the help with the supports. I added the cylinder...

In forum PrusaSlicer

7 months ago
Yes I did have trouble getting abs to print. The problem s...

In forum PrusaSlicer

7 months ago
I'll give some petg or asa a try if I can find it in ivory. ...

In forum PrusaSlicer

7 months ago
Thanks for the extra effort. PLA is where I started. Unfortu...

In forum PrusaSlicer

7 months ago
Thanks for the help. Yes I'm using abs. Pla was too brittle....

In forum PrusaSlicer

7 months ago
Good memory it is the bottom (sole) and negative battery con...

In forum PrusaSlicer

7 months ago
Here is what I get.

In forum PrusaSlicer

7 months ago
Page 1 / 3
Share: