Prusa3D Forum

Notifications

Clear all

jfedor

Group: Registered

Joined: 2019/02/10

Active Member

	I had the same experience with the whistle. In forum Assembly and first prints troubleshooting	6 years ago
	I'd start by cleaning your PEI sheet, not just with isopropy... In forum Hardware, firmware and software help	6 years ago
	I found that if I just want to use the mode where it moves t... In forum User mods - OctoPrint, enclosures, nozzles, ...	6 years ago
	You can use some of the pins that are there for connecting t... In forum Hardware, firmware and software help	6 years ago
	OK, so at least in my case, it's not the software. Out of cu... In forum Hardware, firmware and software help	6 years ago
	Here's what I'm observing, the two temperature towers were p... In forum Hardware, firmware and software help	6 years ago
	I had the exact same problem when using the gcode file from ... In forum Assembly and first prints troubleshooting	6 years ago
	I received two 330mm rods, four 370mm rods and zero 320mm ro... In forum Assembly and first prints troubleshooting	6 years ago

Forum Statistics

579 Forums

65.5 K Topics

457.9 K Posts

35 Online

72.7 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed