Prusa3D Forum

Notifications

Clear all

jer.n

Skupina: Registrovaný

Přidal se: 2020/10/12

Active Member

	Alrighty, so something went bad with my Einsy RAMBo. I swapp... In forum Hardware, firmware and software help	před 5 years
	@karl-herbert @tim-m30 Fuses are good. 24V 'power in' and 'b... In forum Hardware, firmware and software help	před 5 years
	@karl-herbert PSU power cables both were 24.4V. I told it to... In forum Hardware, firmware and software help	před 5 years
	@joantabb I flashed the old 3.8.1 to it and there wasn't any... In forum Hardware, firmware and software help	před 5 years
	Heatbed thermistor is 106 kΩ and extruder is 109 kΩ which ar... In forum Hardware, firmware and software help	před 5 years
	@tim-m30 You're right about increased power. The connectors ... In forum Hardware, firmware and software help	před 5 years
	@tim-m30 I got 14.7 ohms for the hot end and 2.8 ohms for th... In forum Hardware, firmware and software help	před 5 years
	Preheat Error (Hotend and Bed) In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

585 Fóra

68.1 K Témata

477.3 K Příspěvky

15 Online

75.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed