Prusa3D Forum

Notifications

Clear all

jer.n

Group: Registered

Joined: 2020/10/12

Active Member

	Alrighty, so something went bad with my Einsy RAMBo. I swapp... In forum Hardware, firmware and software help	4 years ago
	@karl-herbert @tim-m30 Fuses are good. 24V 'power in' and 'b... In forum Hardware, firmware and software help	4 years ago
	@karl-herbert PSU power cables both were 24.4V. I told it to... In forum Hardware, firmware and software help	4 years ago
	@joantabb I flashed the old 3.8.1 to it and there wasn't any... In forum Hardware, firmware and software help	4 years ago
	Heatbed thermistor is 106 kΩ and extruder is 109 kΩ which ar... In forum Hardware, firmware and software help	4 years ago
	@tim-m30 You're right about increased power. The connectors ... In forum Hardware, firmware and software help	4 years ago
	@tim-m30 I got 14.7 ohms for the hot end and 2.8 ohms for th... In forum Hardware, firmware and software help	4 years ago
	Preheat Error (Hotend and Bed) In forum Hardware, firmware and software help	4 years ago

Forum Statistics

565 Forums

63.4 K Topics

445.5 K Posts

21 Online

68.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed