Notifications
Clear all
jbkmelk
Skupina: Registrovaný
Přidal se: 2023/04/03
Active Member
1
| Avinash, Thanks, I reran the 1st level calibration and adju... | před 12 months | |
| Prints coming up and getting XY axis failure | před 1 year | |
| Thanks, I also, found that there was a bevel in the project ... | před 1 year | |
| First layer issues edges curling | před 1 year | |
| Thanks I'll give it a try. | před 3 years | |
| Any suggestions on a program that is friendly to a newbie? | před 3 years | |
| Trouble with printing a tube | před 3 years | |
| Thank you. Now just need to get it low enough to be able to ... | před 3 years | |
| Can you update the link for this file? I am having the same ... | před 3 years |