Notifications
Clear all
javalabg
javalabg
Group: Registered
Joined: 2019/08/13
Eminent Member
2
Are you using PrusaSlicer 2.8.1? There is under Hadware->...

In forum Hardware, firmware and software help

3 months ago
Oh, Oh, Oh, I've found the problem: using an old custom fila...

In forum Hardware, firmware and software help

3 months ago
but you can manually set the layer height to 0.25

In forum Hardware, firmware and software help

3 months ago
@vhubbard Thank you for reply, I've double checked and canno...

In forum Hardware, firmware and software help

3 months ago
MK4S with HF0.4 nozzle - no benefit against MK4 Inputshaper ...

In forum Hardware, firmware and software help

3 months ago
Thank you for the info about the 11 (wasted?)Watts. Yes, I'l...

In forum General discussion, announcements and releases

7 months ago
Prusa Link sorting by date feature

In forum General discussion & User Experience & Ideas

7 months ago
Answering myself: the Z-Motors are not released in standby-m...

In forum General discussion, announcements and releases

7 months ago
MK4 Z-motors getting warm

In forum General discussion, announcements and releases

7 months ago
Thank you @vhubbard, I did it in a likely manner (with a sol...

In forum Hardware, firmware and software help

7 months ago
Same problem here, from today--> " I'll be able to start ...

In forum Hardware, firmware and software help

7 months ago
Infill of bottom layer in spiral vase mode

In forum PrusaSlicer

4 years ago
@jsw thanks for your thoughts. Indeed, there are many factor...

In forum PrusaSlicer

4 years ago
Holes-clearance for 0.4 nozzle

In forum PrusaSlicer

4 years ago
Sorry, no sulution, I use normal mode and it's not so a big ...

In forum Hardware, firmware and software help

5 years ago
Quick tip for first layer, thin structure and very poor adhe...

In forum Print tips (Archive)

5 years ago
Stealth mode is louder than normal mode

In forum Hardware, firmware and software help

5 years ago
@tim-m30 thank you for this hint, that could be indeed the r...

In forum Hardware, firmware and software help

5 years ago
@bobstro Thank you for the info, good to know that it seems ...

In forum Hardware, firmware and software help

5 years ago
PS: I've double-checked the effect and there is definitely ...

In forum Hardware, firmware and software help

5 years ago
Page 1 / 2
Share: