|
i have the exact same issue today. i wasn't even trying to s... Dans le forum General discussion, announcements and releases |
il y a 2 years |
|
Some good info there. thanks. I will check over stuff on th... Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
Extruder skipping and under extruding Dans le forum Hardware, firmware and software help |
il y a 3 years |
|
thanks this is the first time I’ve ever had a possible expl... Dans le forum PrusaSlicer |
il y a 3 years |
|
What version are you using ? ive found that the new 2.3 ve... Dans le forum PrusaSlicer |
il y a 3 years |
|
After around 50 hours of good printing with no more skipped ... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Little update. not sure exactly why, but I’m now closing in... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Yeah. I realise the pinda itself isn’t the cause. Just odd t... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Thanks for the suggestion as to what to look at next. I’ll c... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Doesn’t look like the nozzle is clogged. Two clean cold pul... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
I’m trying another cold pull or two using the explicit instr... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
That white blob thing didn’t fix the issue. guess I’ll try ... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
I got this that I think is ASA out of the top of the hot end... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Just tried the cold pull using pla and the method in the lin... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Thanks for the info. Good to know. the top two in the pic s... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
I’ll try the prusa recommendation next. See if that improves... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Here’s how I did it. heat to 260°. Load ASA. Allow to cool ... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
This was the first pull. Attached.
B564EEB1-0487-41... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Here’s the results of two cold pulls using ASA. time will t... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
I’m going to try a few cold pulls and see if that removes an... Dans le forum Hardware, firmware and software help |
il y a 4 years |
