Notifications
Clear all
James AZ
Groupe: Enregistré
A(ont) rejoint: 2020/07/01
Active Member
1
|
After updating to 3.13.1, I get the message that: "G-code s... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
@karl-herbert I have tested both old and new hotends and the... Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
LCD say 170, but print head is 250+ and smoking Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
Having just completed the MK3S to MK3s+, I offer the followi... Dans le forum General discussion, announcements and releases |
il y a 5 years | |
|
Not enough filament coming from the nozzle Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
@bobstro Thank you Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
@darcshadow Thank you Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
1st layer not on bed plate Dans le forum Hardware, firmware and software help |
il y a 5 years |