Notifications
Clear all
James AZ
Group: Registered
Joined: 2020/07/01
Active Member
1
|
After updating to 3.13.1, I get the message that: "G-code s... In forum Hardware, firmware and software help |
2 years ago | |
|
@karl-herbert I have tested both old and new hotends and the... In forum Hardware, firmware and software help |
5 years ago | |
|
LCD say 170, but print head is 250+ and smoking In forum Hardware, firmware and software help |
5 years ago | |
| Having just completed the MK3S to MK3s+, I offer the followi... | 5 years ago | |
|
Not enough filament coming from the nozzle In forum Hardware, firmware and software help |
5 years ago | |
|
@bobstro Thank you In forum Hardware, firmware and software help |
5 years ago | |
|
@darcshadow Thank you In forum Hardware, firmware and software help |
5 years ago | |
|
1st layer not on bed plate In forum Hardware, firmware and software help |
5 years ago |