|
Hi Bryan,
I receive the same error message too, but it does... In forum Improvements (Archive) |
10 years ago |
|
I would just replace the glass.
You mentioned that the PCB... In forum Prusa i3 kit (Archive) |
10 years ago |
|
I've been thinking about adding the chimera. But both of tho... In forum Improvements (Archive) |
10 years ago |
|
Peter,
Haha you are right, that is the same thing. But she ... In forum Improvements (Archive) |
10 years ago |
|
I'm glad you like it! I am extremely happy with it. I think ... In forum Improvements (Archive) |
10 years ago |
|
Not sure, haven't bothered to update yet. While I'm aware th... In forum Improvements (Archive) |
10 years ago |
|
I use the IDE all the time to make changes to my firmware an... In forum Improvements (Archive) |
10 years ago |
|
I went ahead and took your advice and set the Z min to 0.0. ... In forum Improvements (Archive) |
10 years ago |
|
Peter
I agree, it's probably best to print PLA at room temp... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Peter,
You are right that is the minimum position, but I be... In forum Improvements (Archive) |
10 years ago |
|
Peter,
I too only need glue applied to the glass bed for my... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Before you clip the glass to the bed, check if the pcb alone... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Use Kapton tape if you REALLY want adhesion. That stuff with... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Peter
Yep, that would be the necessary change I forgot to m... In forum Improvements (Archive) |
10 years ago |
|
Peter
The way I envision full stepping on the Z axis, is to... In forum Improvements (Archive) |
10 years ago |
|
Peter
That is bizarre. Can't figure out any reason for that... In forum Improvements (Archive) |
10 years ago |
|
If stainless steel threaded rods do the trick for you, then ... In forum Improvements (Archive) |
10 years ago |
|
Peter
Sorry, meant to say 0.8mm pitch if you want less chan... In forum Improvements (Archive) |
10 years ago |
|
Peter
Touche.
Didn't think of the X axis as a connection p... In forum Improvements (Archive) |
10 years ago |
|
Peter,
Oh I wasn't aware of that. I only use Slic3r and Cur... In forum Improvements (Archive) |
10 years ago |
