Notifications
Clear all
israel.n
Group: Registered
Joined: 2017/11/11
Active Member
1
|
What slicer software and settings are you using? Can you pos... In forum How do I print this? (Printing help) |
7 years ago | |
|
Problem with STL file In forum How do I print this? (Printing help) |
7 years ago | |
| Settings for TPU | 7 years ago | |
| First layer problem | 7 years ago | |
|
That was weird. I opened them in Simplify3D without any prob... In forum Others (Archive) |
8 years ago | |
|
That was weird. I opened them in Simplify3D without any prob... In forum Others (Archive) |
8 years ago | |
|
Perhaps this one can help you?
HOW TO REPAIR CORRUPTED 3D M... In forum Others (Archive) |
8 years ago | |
|
Can’t print few files In forum Others (Archive) |
8 years ago | |
|
Prusa slicer In forum Others (Archive) |
8 years ago | |
|
Z-offset is too low. Bring it up until that goes away.
Tha... In forum Others (Archive) |
8 years ago | |
|
Z-offset is too low. Bring it up until that goes away.
Tha... In forum Others (Archive) |
8 years ago | |
|
Bad first print the Castle In forum Others (Archive) |
8 years ago |