|
I did quick MK3 settings for Simplify3D.
100um, 150um and 2... En el foro General discussion, announcements and releases |
hace 7 years |
|
I use S3D with no errors, but I'm still tweaking to get resu... En el foro Others (Archive) |
hace 7 years |
|
Problems with Simplify3D En el foro Others (Archive) |
hace 7 years |
|
Yeah, just contacted support after I had posted here.
That'... En el foro Hardware, firmware and software help |
hace 7 years |
|
Do you notice any reduction in ringing? One user posted such... En el foro Others (Archive) |
hace 7 years |
|
UPDATE:
I decided to try a big print this time....
I'm hap... En el foro How do I print this? (Printing help) |
hace 7 years |
|
My X axis rods have the same problem and prusa have send me ... En el foro Hardware, firmware and software help |
hace 7 years |
|
I replaced the three LM8UU ball bearings on the heated bed w... En el foro Others (Archive) |
hace 7 years |
|
UPDATE:
I decided to try a big print this time....
I'm hap... En el foro How do I print this? (Printing help) |
hace 7 years |
|
I stayed on RC3 and dont have this problem, but had on previ... En el foro Others (Archive) |
hace 7 years |
|
I was having the same issue, so I designed a plate so I coul... En el foro Others (Archive) |
hace 7 years |
|
I may have discovered something that may explain both the sq... En el foro How do I print this? (Printing help) |
hace 7 years |
|
Hi Ron,
Thanks for the tips.
I just installed the IGUS on ... En el foro How do I print this? (Printing help) |
hace 7 years |
|
Hey folks... I finally got the printer assembled and its pri... En el foro Others (Archive) |
hace 7 years |
|
what layer height?
Joan
mine took over 24 hours at 0.05mm on... En el foro Others (Archive) |
hace 7 years |
|
Thank you Jason.
Well... just to test it out i decided to c... En el foro How do I print this? (Printing help) |
hace 7 years |
|
Thank you Jason.
Well... just to test it out i decided to c... En el foro How do I print this? (Printing help) |
hace 7 years |
|
Yeah same here, I dont expect better prints from the MK3 but... En el foro How do I print this? (Printing help) |
hace 7 years |
|
Just a tiny difference, dont know if it's any improvement at... En el foro Others (Archive) |
hace 7 years |
|
All,
Thank you so much for the help.
It was a cable conn... En el foro Others (Archive) |
hace 7 years |
